Physics

This writing is lined up so when you read it you look East, and all the

description you will read about magnetic current, it will be just as good for

your electricity.

Following is the result of my two years experiment with magnets at Rock Gate,

seventeen miles Southwest from Miami, Florida. Between Twenty-fifth and

Twenty-sixth Latitude and Eightieth and Eighty-first Longitude West.

First I will describe what a magnet is. You have seen straight bar magnets, U

shape magnets, sphere or ball magnets and Alnico magnets in many shapes, and

usually a hole in the middle. In all magnets one end of the metal is North

Pole and the other South Pole, and those which have no end one side is North

Pole and the other South Pole.

Now about the sphere magnet. if you have a strong magnet you can change the

poles in the sphere in any side you want or take the poles out so the sphere

will not be a magnet any more. From this you can see that the magnet can be

shifted and concentrated and also you can see that the metal is not the real

magnet. The real magnet is the substance that is circulating in the metal.

Each particle in the substance is an individual magnet by itself, and both

North and South Pole individual magnets. They are so small that they can pass

through anything.. In fact they can pass through metal easier than through the

air. They are in constant motion, they are running one kind of magnets against

the other kind, and if guided in the right channels they possess perpetual

power. The North and South Pole magnets they ore cosmic force, they hold

together this earth and everything on it. Each North and South Pole magnet is

equal in strength, but the strength of each individual magnet doesn't amount

to anything. To be of practical use they will have to be in great numbers.

In permanent magnets they are circulating in the metal in great numbers, and

they circulate in the following way: Each kind of the magnets are coming out

of their own end of the pole and are running around, and are running in the

other end of the pole and back to its own end, and then over and over again.

All the individual magnets do not run around. Some run away and never come

back, but new ones take their place.

The earth itself is a great big magnet. In general these North and South Pole

individual magnets are circulating in the same way as in the permanent magnet

metal. The North Pole individual magnets are coming out of the earth's South

Pole and are running around in the earth's North Pole and back to its own

pole, and South Pole individual magnets are coming out of the earth's North

Pole and are running around, and in earth South Pole and back to its own end.

Then both North and South Pole individual magnets start to run over and over

again.

In a permanent magnet bar between the poles there is a semi-neutral part where

there is not much going in or out, but on the earth there is no place where

the magnets are not going in or out, but the magnets are running in and out at

pole ends more than at the Equator. Now you get the equipment and I will tell

you so you can see for yourself that it is in the way I have told, Get a

permanent magnet bar four inches long. A U shape magnet that is strong enough

to lift from ten to twenty pounds. An Alnico magnet about three inches long,

two and one-half inches wide, one-inch thick, Hole in the middle and poles in

each end, several feet in length of hard steel fishing line. Line when it is

not in coil it stays straight and a soft steel welding rod one-eighth of an

inch thick and three feet long. From the fishing wire and the welding rod

you will make magnets or compasses, and if you hang them up in fine threads by

middle and keep them there they will be permanent magnets.

When you are making a magnet pole in the welding rod use U shape magnet. South

Pole magnet to make North Pole magnet in the rod and use U shape North Pole

magnet to make South Pole magnet in the rod. You can drag the magnet over the

rod from end to end, but never stop in middle. If you stop in middle there

will be an extra pole so it will disturb the magnet's circulation. Use iron

filings to test the rod if there is any magnets