Hydroeclectric Power

Of the renewable energy sources that generate electricity, hydropower is the most often used. It accounted for 7 percent of total U.S. electricity generation and 75 percent of generation from renewables in 2004.

It is one of the oldest sources of energy and was used thousands of years ago to turn a paddle wheel for purposes such as grinding grain. Our nation's first industrial use of hydropower to generate electricity occurred in 1880, when 16 brush-arc lamps were powered using a water turbine at the Wolverine Chair Factory in Grand Rapids, Michigan. The first U.S. hydroelectric power plant opened on the Fox River near Appleton, Wisconsin, on September 30, 1882. Until that time, coal was the only fuel used to produce electricity. Because the source of hydropower is water, hydroelectric power plants must be located on a water source. Therefore, it wasn't until the technology to transmit electricity over long distances was developed that hydropower became widely used.

HOW HYDROPOWER WORKS

Image of the water cycle. Solar energy heats water on the surface, causing it to evaporate. This water vapor condenses into clouds and falls back onto the surface as precipitation. The water flows through rivers back into the oceans, where it can evaporate and begin the cycle over again.

Understanding the water cycle is important to understanding hydropower. In the water cycle -

# Solar energy heats water on the surface, causing it to evaporate.

# This water vapor condenses into clouds and falls back onto the surface as precipitation.

# The water flows through rivers back into the oceans, where it can evaporate and begin the cycle over again.

Mechanical energy is derived by directing, harnessing, or channeling moving water. The amount of available energy in moving water is determined by its flow or fall. Swiftly flowing water in a big river, like the Columbia River along the border between Oregon and Washington, carries a great deal of energy in its flow. So, too, with water descending rapidly from a very high point, like Niagara Falls in New York. In either instance, the water flows through a pipe, or penstock, Image of how a hydropower plant works. The water flows from behind the dam through penstocks, turns the turbines, and causes the generators to generate electricity. The electricity is carried to users by a transmission line. Other water flows from behind the dam over spillways and into the river below.then pushes against and turns blades in a turbine to spin a generator to produce electricity. In a run-of-the-river system, the force of the current applies the needed pressure, while in a storage system, water is accumulated in reservoirs created by dams, then released when the demand for electricity is high.